293034313212332526272822242335TM 9-4940-568-345-140 5-23. STARTER MOTOR REPAIR (CONT). c.Disassembly of Gear Reduction and Drive Group.NOTEBefore removing armature supportbracket from assembled drivehousing, make aligning marks onthe armature support bracket andthe drive housing to aid inassembly.(1)Remove long drive housing bolt (22) andshort drive housing bolt (23) from thearmature support bracket (24).(2)Remove armature support bracket (24) fromthe drive shaft and clutch group (25).NOTEWashers might stick to armaturesupport bracket or the drive shaftand clutch group as the armaturesupport bracket is removed. Ineither case, note the position andnumber of each of these washers.(3)Remove fiber washer(s) (26), thin washer(s)(27), and thick washer(s) (28).(4)Using a large screwdriver, pry out the drivehousing plug (29) and plate (30) from drivehousing (12).(5)Remove shift lever nut (31), shift leverwasher (32), and shift lever screw (33) fromshift lever (34) and assembled drive shaftand clutch group (25).(6)Remove shift lever (34) and drive shaft andclutch group (25) from drive housing (12).Separate shift lever (34) and drive shaft andclutch group (25) from each other.NOTEDo not remove bushing plug orbushing from drive housingunless replacement is required.(7)From inside of drive housing (12), drive outbushing plug (35) if present. Using a cleanfile, clean away remnants of old stake toallow installation of new bushing plug. Cleanaway any metal shavings.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
