13
14
15
16
3
12
TM 9-4940-568-34
5-138
5-23. STARTER MOTOR REPAIR (CONT).
NOTE
Armature assembly may come
off with the frame and field
assembly, the brush holder
assembly, or it may be retained
by the gear reduction and drive
group.
(6)
Remove armature assembly (13) with drive
end armature bearing (14) and commutator
end armature bearing (15) installed.
NOTE
Do not remove armature bearings
unless replacement is required.
Removed bearings must be
replaced with new armature
bearings. Removal procedure
causes internal damage to
armature bearings.
(7)
Remove drive end armature bearing (14)
and commutator end armature bearing (15)
from armature assembly (13). Discard
bearings.
(8)
Remove two solenoid screws (16) from
solenoid assembly (3).
(9)
Pivot inside end of solenoid assembly (3)
out of engagement with shift lever and
remove solenoid assembly from drive
housing (12).
(10)
After all items in Steps (1) through (9) have
been removed, perform inspection and
testing procedures.
