TM 9-2330-389-14&P
4-28.
TIRE ASSEMBLY REPLACEMENT (Con’t)
1.
Position tire assembly (7) over studs on axle hub (8). Install, but do not tighten, eight lugnuts (1).
2.
Raise axle assembly (2) high enough to remove jack stands using a hydraulic jack. Remove jack stands and
lower track (3) to ground. Remove hydraulic jack.
3
Torque lugnuts (1) evenly to 90-100 Ib.-ft. (122-136 Nm). Remove blocking.
WARNING
Compressed air used for cleaning or drying purposes, or for cleaning restrictions,
should never exceed 30 psi (207 kPa). Wear protective clothing (goggles/shield,
gloves, etc.) and use caution to avoid Injury to personnel.
4.
Inflate all tire assemblies to 40 psi (275 kPa) (cold).
4-35
