TM 9-2330-389-14&P
4-29.
TIRE MAINTENANCE.
Refer to TM 9-2610-200-24 for instructions on tire maintenance.
4-30.
TRACK BELT MAINTENANCE.
This Task Covers:
a.
Removal
b.
Installation
c.
Adjustment and Alignment
Initial Setup:
Tools/Test Equipment:
Personnel Required: Two
Common #1 tool set
General mechanic's tool kit
Master mechanic's tool kit
a.
REMOVAL
1.
Apply parking brake and block the opposite-side track (refer to TM 9-2330-205-14&P).
2.
Raise cross axle (1) until track belt (2) to be removed is clear of ground with hydraulic jack. Support cross axle
(1) with jack stands or blocking.
3.
Deflate and remove outer front and rear tire assemblies (para 4-28). Deflate but do not remove inner front and
rear tire assemblies (3).
CAUTION
Do not loosen the track alignment or adjustment screws, located on each side of
the frame group. Failure to tighten the adjustment screw will allow the frame
group to move freely and damage the track belt
4.
With the aid of an assistant, lift track belt (2) off inner front and rear tire assemblies (3) and away from trailer (4).
4-36
