ADJUSTMENT AND ALIGNMENT - cont - TM-9-2330-389-14P

ADJUSTMENT AND ALIGNMENT - cont - TM-9-2330-389-14P_64

TM-9-2330-389-14P Trailer Palletized Load System (PLST) M1076 Manual
Page Navigation
59

TM 9-2330-389-14&P 4-30. TRACK BELT MAINTENANCE (Con’t). 4. Loosen both inner and outer self-locking nuts (10). 5. Loosen outer capscrew (11) one turn and tighten inner capscrew (11) one turn. Ensure capscrew (6) is against inner block when tightening. Resistance must be felt to ensure capscrew (6) is bottomed. 6. Loosen inner capscrew (11) one turn and tighten outer capscrew (11) one turn. Ensure capscrew (6) is against inner block when tightening. Resistance must be felt to ensure capscrew (6) is bottomed. 7. Tighten all four self-locking nuts (10). 8. Repeat steps 3-7 until track belt alignment is correct. 4-31. IDLER HUB MAINTENANCE. This Task Covers: a. Removal b. Disassembly c. Repair d. Assembly e. Installation f. Adjustment Initial Setup: Equipment Conditions: Materials/Parts: Rear tire assembly removed (para 4-28). Dry cleaning solvent (Item 6, Appendix E) Grease (Item 3, Appendix E) Tools/Test Equipment: Cotter pin, MS24665-423 Common #1 tool set Lip type seal, 5M9740 General mechanic's tool kit References: TM Q-914 a. REMOVAL CAUTION To prevent damage, avoid prolonged hammering on one area of the grease cap shoulder. Tapping around the circumference will prevent binding. 4-40

Privacy Statement
Press Release
Contact