TM 5-3895-376-14&P
5-23. VIBRATOR MAINTENANCE INSTRUCTIONS - Continued
cure with four countersunk lockwashers (11) and
13. Install the selected shims (16, 17, and 18) for the
flat head screws (10). Torque screws to 17 ft-lbs
adjustable shaft (42) against the bearing cup in-
(33 Nm) with torque wrench fitted with 6 mm hex
stalled in the cover (27) Reinstall the new gas-
key driver.
ket (15) and bearing cover (12) and secure with
countersunk lockwashers (11) and flat head
17. install key (9) in key slot of projecting end of
screws (10) Torque screws to 17 ft-lbs (23 Nm)
shaft (49) and install pulley (8) on shaft engaging
with torque wrench fitted with 6 mm hex key
the key (9).
driver.
18. Secure pulley (8) with retaining washer (7), coun-
14. Install the selected shims (16, 17, and 18) for the
tersunk washer (6) and flat head screw (5).
fixed shaft (49) against the bearing cup instalIed
Tighten screw securely.
in the housing (50) Reinstall the new gasket (15)
and bearing cover (12) and secure with counter
19. V-belt guard (4) need not be installed at this time,
sunk lockwashers (11) and flat head screws (10)
if vibrator is to be immediately installed on a com-
Torque screws to 17 ft-lbs (23 Nm) with torque.
pactor
wrench fitted with 6 mm hex key driver.
15. Install new seal ring (14) in bearing cover (13),
NOTE
flush with outside surface of the cover.
Follow-on tasks include: Install vibrator as-
sembly (Para. 4-13). Install control housing
16.
Install new gasket (15) and carefully install the
(Para 4-19), direction cable and control
bearing cover (13) with seal ring (14) over project-
(Para 4-19), and service the vibrator as-
ing end of shaft (49) and seat in cover (22). Se
sembly (Para 4-13).
5-76