TM 5-3895-376-14&P
4-19. DIRECTION CONTROL LEVER MAINTENANCE INSTRUCTIONS
This task includes
d. Installation
a. Remove
e. Adjust
b. Cleaning
c. Inspection
INITIAL SETUP
Lockwasher, M8 (5)
Tools
Lockwasher, M10(1)
Too kit, General Mechanic's
Lockwasher, Countersunk, M6 (3)
SNAP Ring Plier, item 20, Appx E
Washer, Bevel (2)
Wrench Torque, item 50, Appx E
Equipment Condition
Materials/Parts
Compactor set on level ground in protected area
Solvent, Dry Cleaning : item 9. Appx E
Engine off
Rag, Wiping: item 8, Appx E
Seal Ring (1)
General Safety Instructions
Preformed Packing (2)
Observe all WARNINGS and CAUTIONS
Lockwasher, M6 (1)
5.
Remove capscrew (17), lockwasher (18), and
lever (19) from end of turning bolt (23)
1. Remove control cable (1) as follows:
6.
If further disassembly is required proceed as fol-
lows:
a. Disconnect control cable (1) from control
lever (10) by removing the yoke pin at yoke
a . Remove v-belt cover (Para. 4-24)
end (2).
b . Separate engine base from base plate (Para.
b. Disconnect control cable (1) from lever (19)
4-40). removing the v-belt from clutch pulley.
by removing the yoke pin at yoke end (3).
c. Lift assembled engine and engine base from
c. Loosen nuts (5) on the control cable to re-
base plate (Para 4-40).
move control cable (1) from bracket on guide
bar.
d . Remove two capscrews (20,), lockwashers
(21) and cable holder (22).
d. Loosen nuts (5) on the control cable to re-
move control cable (1) from bracket of cable
e . Pull turning bolt (23) out of control housing
holder (22).
(38), a slight twisting motion may be required.
2. Remove control lever (10), by removing hex
f.
Remove spacer (24) seal ring (25). and tow
nut (6), capscrew (7), flat washer, (8) and two
preformed packings (26). Discard the seal
bevel washers (9).
ring and preformed packings.
3. Remove button plugs (11) from ends of control
Remove pin (27) only if replacement is neces-
g.
lever (10).
sary.
4. Remove hex nut (12), lockwasher (13), capscrew
h . Remove three flat screws (28) and
(14), flat washer (15), and eccentric ring (16)
countersunk lockwashers (29), that secure.
from guide bar.
4-22