TM 5-3805-296-23-2
0104
Table 1. Engine Will Not Crank Continued.
0104
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Engine WIll Not Crank
Test Step 12. Test for Shorted Start
Continued
Relay.
1. Remove start relay from circuit
breaker panel (Figure 10).
2. Remove flood enable relay from
circuit breaker panel (Figure 10).
Install flood enable relay on start
relay connector on circuit breaker
panel.
Figure 10. Start Relay and Flood Enable Relay.
0104
3. Install new fuse F13 on circuit
breaker panel
(TM 5-3805-296-10).
CAUTION
Do not crank engine for more than 30 seconds. Allow starter to cool for
two minutes before cranking again. Failure to follow this caution may
result in damage to equipment.
4. Turn battery disconnect switch to
ON position and start engine
(TM 5-3805-296-10).
5. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
6. Remove fuse F13 from circuit
breaker panel
(TM 5-3805-296-10).
