TM 5-3805-296-23-2
0104
Table 1. Engine Will Not Crank Continued.
0104
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CAUTION
Engine WIll Not Crank
Continued
Do not crank engine for more than 30 seconds. Allow starter to cool for
two minutes before cranking again. Failure to follow this caution may
result in damage to equipment.
2. Turn battery disconnect switch to
Engine Cranks Turn ignition switch
ON position and start engine
and battery disconnect switch to OFF
(TM 5-3805-296-10).
position (TM 5-3805-296-10).
Install flood enable relay on flood
enable relay connector on circuit
breaker panel.
Install new start relay on circuit breaker
panel.
Proceed to Test Step 27.
Engine Does Not Crank
Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
Install flood enable relay on flood
enable relay connector on circuit
breaker panel.
Install start relay on circuit breaker
panel.
Proceed to Test Step 8.
Test Step 8. Test Starter Amperage
Draw.
1. Open cover (Figure 7, Item 1),
move switch (Figure 7, Item 2)
upward to engine stop position. Do
not close cover.
Figure 7. Engine Shutoff Switch.
0104
