TM 5-3805-296-23-2
0098
Table 1. 0324 Action Lamp Diagnostic Codes Continued.
098
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test Dash Wiring
0324-05 Warning Lamp
Harness for High Resistance or
Open/Short to Ground
Open.
Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove apron float LED from
connector P-C31 and install LED
on connector P-C22. Connect
connector P-C22 on instrument
panel (WP 0506) (Figure 2).
3. Disconnect connector P-C18
(WP 0012, Figure 269) from tractor
operator monitor connector.
4. Connect jumper wire between
terminal 2 and terminal 13 of
connector P-C18
(WP 0012, Figure 269).
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace tractor operator monitor
between connector terminals of
(WP 0506).
connector P-C31
Proceed to Test Step 3.
(WP 0012, Figure 322).
Resistance Greater Than 5.0 Ohms
Replace dash wiring harness
(WP 0510).
Proceed to Test Step 3.
Test Step 3. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
324-5 Warning Lamp Open/Short To
Ground Becomes Inactive Proceed
diagnostic codes (WP 0008).
to step 4.
324-5 Warning Lamp Open/Short To
Ground Remains Active Repeat
troubleshooting from the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. If removed, install instrument panel
(Figure 6, Item 3) with six bolts
(Figure 6, Item 4) on ROPS
(Figure 6, Item 5).
0098-9