TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Check for Other Active
0702-08 Transmission Gear
Codes.
Lever Selector Sensor
1. Turn battery disconnect switch and
(Switch) Abnormal Signal
ignition switch to ON position
Continued
(TM 5-3805-296-10).
2. Connect MSD. Select
702-3 Transmission Gear Lever
Transmission 621G and check for
Selector Sensor (Switch) Voltage
active diagnostic codes:
Above Normal Active Diagnose and
a. 702-3 Transmission Gear
repair active code as described in this
Lever Selector Sensor
work package.
(Switch) Voltage Above
702-4 Transmission Gear Lever
Normal.
Selector Sensor (Switch) Voltage
Below Normal Active Diagnose and
b. 702-4 Transmission Gear
repair active code as described in this
Lever Selector Sensor
work package.
(Switch) Voltage Below
Only 702-8 Transmission Gear Lever
Normal.
Selector Sensor (Switch) Abnormal
Signal Active Proceed to Test Step 2.
Test Step 2. Inspect Transmission
Control.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C13
(WP 0012, Figure 304) from
transmission shifter connector B
(WP 0012, Figure 303).
3. Inspect transmission control for
Control OK Proceed to step 4.
damage (WP 0502).
Control Damaged Replace
transmission control (WP 0502).
Proceed to Test Step 11.
4. Inspect connector CG-C13
Connector CG-C15 Damaged
(WP 0012, Figure 304) for damage
Replace fuse panel wiring harness
IAW Electrical General
(WP 0515).
Maintenance Procedures
Proceed to Test Step 11.
(WP 0540).
No Problem Found Proceed to Test
Step 3.
0065-10
