TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Inspect Implement
0702-04 Transmission Gear
Control Joystick Assembly.
Lever Selector Sensor
1. Turn ignition switch and battery
(Switch) Voltage Below
disconnect switch to OFF position
Normal Continued
(TM 5-3805-296-10).
2. Inspect transmission control for
Control OK Proceed to Test Step 2.
damage (WP 0502).
Control Damaged Replace
transmission control (WP 0502).
Proceed to Test Step 5.
Test Step 2. Test Transmission
Shifter Circuit Function.
1. Disconnect connector CG-C13
(WP 0012, Figure 304) from
transmission shifter connector B
(WP 0012, Figure 303).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
702-3 Transmission Gear Lever
diagnostic code 702-4
Selector Sensor (Switch) Voltage
Transmission Gear Lever Selector
Above Normal Becomes Active
Sensor (Switch) Voltage Below
Replace transmission control
Normal (WP 0008).
(WP 0502).
Proceed to Test Step 5.
702-4 Transmission Gear Lever
Selector Sensor (Switch) Voltage
Below Normal Remains Active
Proceed to Test Step 3.
Test Step 3. Test for Shorted Fuse
Panel Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012,Figure 282).
3. Using digital multimeter
Continuity Replace fuse panel wiring
(WP 0540), test for continuity
harness (WP 0515).
between connector CG-C1
Proceed to Test Step 5.
terminal 54 (WP 0012, Figure 283)
No Continuity Proceed to step 4.
and all other terminals
in connector CG-C1
(WP 0012, Figure 283).
0065-7
