TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
0702-03 Transmission Gear
Continuity Replace main cab wiring
(WP 0540), test for continuity
Lever Selector Sensor
harness (WP 0505).
between connector W-C12
(Switch) Voltage Above
Proceed to Test Step 9.
terminal 26 (WP 0012, Figure 88)
Normal Continued
No Continuity Replace transmission/
and all terminals in connector W-
chassis ECM (WP 0495).
C13 (WP 0012, Figure 89).
Proceed to Test Step 9.
Test Step 5. Test Fuse Panel Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal 2 and terminal 3 of
connector CG-C13 (WP 0012,
Figure 304).
3. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between connector CG-C1
Resistance Greater Than 5.0 Ohms
terminal 54 and terminal 67
Replace fuse panel wiring harness
(WP 0012, Figure 283).
(WP 0515).
Proceed to Test Step 9.
Test Step 6. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 2 and terminal 3
of connector CG-C13
(WP 0012, Figure 304).
2. Connect jumper wire between
terminal 54 and terminal 67
of connector W-C8
(WP 0012, Figure 282).
3. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace transmission/chassis ECM
between connector W-C12
(WP 0495).
terminal 12 and terminal 26
Proceed to Test Step 9.
(WP 0012, Figure 88).
Resistance Greater Than 5.0 Ohms
Replace main cab wiring harness
(WP 0505).
Proceed to Test Step 9.
0065-4