TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
0702-03 Transmission Gear
Voltage 18 to 25 V Proceed to Test
(WP 0540), test for voltage
Lever Selector Sensor
Step 7.
between connector CG-C13
(Switch) Voltage Above
Voltage Less Than 18 V Proceed to
terminal 1 (WP 0012, Figure 304)
Normal Continued
Test Step 8.
and ground.
Test Step 3. Test for Shorted Fuse
Panel Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
3. Using digital multimeter
Continuity Replace fuse panel wiring
(WP 0540), test for continuity
harness (WP 0515).
between connector CG-C1
Proceed to Test Step 9.
terminal 54 (WP 0012, Figure 283)
No Continuity Proceed to Test
and all other terminals
Step 4.
in connector CG-C1
(WP 0012, Figure 283).
Test Step 4. Test for Shorted Main
Cab Wiring Harness.
1. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
2. Disconnect connector W-C13
(WP 0012, Figure 89) from
transmission/chassis ECM.
3. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C8
Proceed to Test Step 9.
terminal 54 (WP 0012, Figure 282)
No Continuity Proceed to step 4.
and all other terminals
in connector W-C8
(WP 0012, Figure 282).
4. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C12
Proceed to Test Step 9.
terminal 26 (WP 0012, Figure 88)
No Continuity Proceed to step 5.
and all other terminals
in connector W-C12
(WP 0012, Figure 88).
0065-3