TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 5. Test Main Cab Wiring
0702-08 Transmission Gear
Harness for High Resistance or
Lever Selector Sensor
Open.
(Switch) Abnormal Signal
1. Remove jumper wire from
Continued
terminal 2 and terminal 3
of connector CG-C13
(WP 0012, Figure 304).
2. Connect jumper wire between
terminal 54 and terminal 67
of connector W-C8
(WP 0012, Figure 282).
3. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
(WP 0540), measure resistance
Replace transmission/chassis ECM
between connector W-C12
(WP 0495).
terminal 12 and terminal 26
Proceed to Test Step 11.
(WP 0012, Figure 88).
Replace main cab wiring harness
(WP 0505).
Proceed to Test Step 11.
Test Step 6. Inspect Fuse Panel
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
3. Inspect connector CG-C1
Connector CG-C1 Damaged -
(WP 0012, Figure 283) for damage
Replace fuse panel wiring harness
IAW Electrical General
(WP 0515).
Maintenance Procedures
Proceed to Test Step 11.
(WP 0540).
No Problem Found - Proceed to Test
Step 7.
0065-12