TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 3. Test Transmission
0702-08 Transmission Gear
Shifter Circuit, Battery + Circuit, and
Lever Selector Sensor
Ground Circuit Function.
(Switch) Abnormal Signal
1. Turn battery disconnect switch and
Continued
ignition switch to ON position
(TM 5-3805-296-10).
2. Using digital multimeter
Voltage 4.5 to 5.5 V Proceed to
(WP 0540), test for voltage
step 3.
between connector CG-C13
Voltage Less Than 4.5 V Proceed to
terminal 3 and terminal 2
Test Step 4.
(WP 0012, Figure 304).
3. Using digital multimeter
Voltage 18 to 25 V Proceed to Test
(WP 0540), test for voltage
Step 6.
between connector CG-C13
Voltage Less Than 18 V Proceed to
terminal 1 (WP 0012, Figure 304)
Test Step 10.
and ground.
Test Step 4. Test Fuse Panel Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal 2 and terminal 3
of connector CG-C13
(WP 0012, Figure 304).
3. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 5.
between connector CG-C1
Resistance Greater Than 5.0 Ohms
terminal 54 and terminal 67
Replace fuse panel wiring harness
(WP 0012, Figure 283).
(WP 0515).
Proceed to Test Step 11.
0065-11
