TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 9. Verify Malfunction is
0702-08 Transmission Gear
Resolved.
Lever Selector Sensor
1. Ensure all harness connectors are
(Switch) Abnormal Signal
connected.
Continued
2. Turn battery disconnect switch to
ON position, start engine, depress
brake pedal, and move gear shift
lever into each gear position
and then back to neutral
(TM 5-3805-296-10).
3. At MSD, check for active
702-8 Transmission Gear Lever
Selector Sensor (Switch) Abnormal
diagnostic codes (WP 0008).
Signal Becomes Inactive Proceed to
step 4.
702-8 Transmission Gear Lever
Selector Sensor (Switch) Abnormal
Signal Remains Active Replace
transmission/chassis ECM (WP 0495).
Proceed to Test Step 11.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. Install right trim panels on ROPS
(WP 0494).
6. Troubleshooting complete.
Test Step 10. Test Fuse Panel Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal 1 and terminal 2
of connector CG-C13
(WP 0012, Figure 304).
3. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace main cab wiring harness
between connector CG-C1
(WP 0505).
terminal 1 and terminal 67
Proceed to Test Step 11.
(WP 0012, Figure 283).
Resistance Greater Than 5.0 Ohms
Replace fuse panel wiring harness
(WP 0515).
Proceed to Test Step 11.
0065-14