TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 8. Test Chassis Wiring
0700-03 Transmission Gear
Harness for High Resistance or
Sensor Voltage Above
Open.
Normal Continued
1. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
2. Using digital multimeter
Resistance 5.0 Ohms or Less at All
(WP 0540), connect jumpers and
Test Points Proceed to Test Step 9.
measure resistance between the
Resistance Greater Than 5.0 Ohms at
following:
One or More Test Points Replace
a. Connect jumper wire between
chassis wiring harness (WP 0305).
terminal 38 and 39 of
Proceed to Test Step 13.
connector J-C8
(WP 0012, Figure 100) and
measure resistance between
connector J-C3 terminal 29
and terminal 30
(WP 0012, Figure 101).
b. Remove jumper wire from
terminal 38 and 39
of connector J-C8
(WP 0012, Figure 100).
c.
Connect jumper wire between
terminal 37 and 64
of connector J-C8
(WP 0012, Figure 100) and
measure resistance between
connector J-C3 terminal 27
and terminal 28
(WP 0012, Figure 101).
d. Remove jumper wire from
terminal 37 and 64
of connector J-C8
(WP 0012, Figure 100).
e. Connect jumper wire between
terminal 34 and 35
of connector J-C8
(WP 0012, Figure 100) and
measure resistance between
connector J-C3 terminal 25
and terminal 26
(WP 0012, Figure 101).
f. Remove jumper wire from
terminal 34 and 35 of connector
J-C8 (WP 0012, Figure 100).
0064-38