TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 9. Test Main Cab Wiring
0700-03 Transmission Gear
Harness for High Resistance or
Sensor Voltage Above
Open.
Normal Continued
1. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
2. Using digital multimeter
Resistance 5.0 Ohms or Less at All
(WP 0540), measure resistance
Test Points Proceed to Test Step 10.
between the following:
Resistance Greater Than 5.0 Ohms at
a. Connector W-C1 terminal 39
One or More Test Points Replace
(WP 0012, Figure 99) and
main cab wiring harness (WP 0505).
connector W-C12 terminal 39
Proceed to Test Step 13.
(WP 0012, Figure 88).
b. Connector W-C1 terminal 38
(WP 0012, Figure 99) and
connector W-C12 terminal 28
(WP 0012, Figure 88).
c.
Connector W-C1 terminal 37
(WP 0012, Figure 99) and
connector W-C12 terminal 29
(WP 0012, Figure 88).
d. Connector W-C1 terminal 64
(WP 0012, Figure 99) and
connector W-C12 terminal 30
(WP 0012, Figure 88).
e. Connector W-C1 terminal 35
(WP 0012, Figure 99) and
connector W-C12 terminal 31
(WP 0012, Figure 88).
f.
Connector W-C1 terminal 34
(WP 0012, Figure 99) and
connector W-C12 terminal 55
(WP 0012, Figure 88).
g. Connector W-C1 terminal 5
(WP 0012, Figure 99) and
connector W-C12 terminal 9
(WP 0012, Figure 88).
h. Connector W-C1 terminal 5
(WP 0012, Figure 99) and
connector W-C12 terminal 20
(WP 0012, Figure 88).
0064-40