TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 10. Verify if Code is Still
0700-03 Transmission Gear
Active.
Sensor Voltage Above
1. Connect connector W-C12
Normal Continued
(WP 0012, Figure 88) to
transmission/chassis ECM.
2. Connect connector J-C8
(WP 0012, Figure 100)
to connector W-C1
(WP 0012, Figure 99).
3. Connect connector A-C1
(WP 0012, Figure 106)
to connector J-C3
(WP 0012, Figure 101).
4. Connect connector AG-C1
(WP 0012, Figure 120) to tractor
actual gear switch connector
(WP 0012, Figure 119) (WP 0273).
5. Turn battery disconnect switch to
ON position, start engine, depress
brake pedal, and move gear shift
lever into each gear position and
then back to neutral (TM 5-3805-
296-10).
700-3 Transmission Gear Sensor
6. At MSD, check for active
Voltage Above Normal Becomes
diagnostic code 700-3
Inactive Proceed to step 7.
Transmission Gear Sensor Voltage
700-3 Transmission Gear Sensor
Above Normal (WP 0008).
Voltage Above Normal Remains
Active Replace transmission/chassis
ECM (WP 0495).
Proceed to Test Step 13.
7. Install tractor actual gear switch
(WP 0273).
8. Troubleshooting complete.
Test Step 11. Test Transmission
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
0064-41