TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0700-03 Transmission Gear
3. Using digital multimeter
Resistance 5.0 Ohms Or Less
Sensor Voltage Above
(WP 0540), measure resistance
Proceed to Test Step 12.
Normal Continued
between connector AG-C1
Resistance Greater Than 5.0 Ohms
terminal 2 (WP 0012, Figure 120)
Replace transmission wiring harness
and connector A-C1 terminal 31
(WP 0266).
(WP 0012, Figure 106).
Proceed to Test Step 13.
Test Step 12. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Disconnect connector J-C8
(WP 0012, Figure 100) from
connector W-C1 (WP 0012,
Figure 99).
2. Using digital multimeter
Resistance 5.0 Ohms Or Less
(WP 0540), measure resistance
Replace main cab wiring harness
between connector J-C3
(WP 0505).
terminal 31 (WP 0012, Figure 101)
Proceed to Test Step 13.
and connector J-C8 terminal 44
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 100).
Replace chassis wiring harness
(WP 0305).
Proceed to Test Step 13.
Test Step 13. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch
to ON position, start engine,
depress brake pedal, and move
gear shift lever into each gear
position and then back to neutral
(TM 5-3805-296-10).
3. At MSD, check for active
700-3 Transmission Gear Sensor
diagnostic codes (WP 0008).
Voltage Above Normal Becomes
Inactive Proceed to step 4.
700-3 Transmission Gear Sensor
Voltage Above Normal Remains
Active Repeat troubleshooting from
the beginning.
4. Install tractor actual gear switch
(WP 0273).
5. Troubleshooting complete.
END OF WORK PACKAGE
0064-42