TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 7. Test Transmission
0700-03 Transmission Gear
Wiring Harness for High Resistance
Sensor Voltage Above
or Open.
Normal Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
3. Using digital multimeter
Resistance 5.0 Ohms or Less at All
(WP 0540), measure resistance
Test Points Proceed to Test Step 8.
between the following:
Resistance Greater Than 5.0 Ohms at
a. Connector AG-C1 terminal 3
One or More Test Points Replace
(WP 0012, Figure 120) and
transmission wiring harness
connector A-C1 terminal 30
(WP 0266).
(WP 0012, Figure 106).
Proceed to Test Step 13.
b. Connector AG-C1 terminal 9
(WP 0012, Figure 120) and
connector A-C1 terminal 29
(WP 0012, Figure 106).
c.
Connector AG-C1 terminal 4
(WP 0012, Figure 120) and
connector A-C1 terminal 28.
d. Connector AG-C1 terminal 7
(WP 0012, Figure 120) and
connector A-C1 terminal 27
(WP 0012, Figure 106).
e. Connector AG-C1 terminal 1
(WP 0012, Figure 120) and
connector A-C1 terminal 26.
f.
Connector AG-C1 terminal 6
(WP 0012, Figure 120) and
connector A-C1 terminal 25.
g. Connector AG-C1 terminal 10
(WP 0012, Figure 120) and
connector A-C1 terminal 18.
0064-37