TM 5-3805-296-23-1
0041
Table 1. 2417 Start Aid Diagnostic Codes Continued.
041
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 7. Test Hood Wiring
2417-05 Ether Injection
Harness for High Resistance or
Control Solenoid Current
Open.
Below Normal Continued
1. Connect jumper wire between
terminal 1 and terminal 2
of connector L-C6
(WP 0012, Figure 221).
2. Disconnect connector L-C1
(WP 0012, Figure 190)
from connector J-C2
(WP 0012, Figure 189).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 8.
between connector L-C1
Resistance Greater Than 5.0 Ohms
terminal 8 and terminal 10
Replace hood wiring harness
(WP 0012, Figure 190).
(WP 0389).
Proceed to Test Step 10.
Test Step 8. Inspect Ground Point of
Chassis Wiring Harness.
1. Remove jumper wire from terminal
1 and terminal 2 of connector L-C6
(WP 0012, Figure 221).
2. Inspect ground point of
Ground Point or Ring Terminal Dirty
chassis wiring harness
or Corroded Clean as necessary.
(WP 0012, Figure 314) for dirt,
Proceed to Test Step 10.
corrosion, and damage.
Ring Terminal Defective Replace
chassis wiring harness (WP 0305).
Proceed to Test Step 10.
No Problem Found Proceed to Test
Step 9.
Test Step 9. Test Ground Circuit
Function.
Using digital multimeter (WP 0540),
Resistance 5.0 Ohms or Less
measure resistance between
Proceed to Test Step 10.
connector J-C2 terminal 10
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 189) and ground.
Replace chassis wiring harness
(WP 0305).
Proceed to Test Step 10.
0041-6