TM 5-3805-296-23-1
0041
Table 1. 2417 Start Aid Diagnostic Codes Continued.
041
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
2417-5 Ether Injection Control
5. At MSD, check for active
2417-05 Ether Injection
Solenoid Current Below Normal
diagnostic code 2417-5 Ether
Control Solenoid Current
Becomes Inactive Replace ether
Injection Control Solenoid Current
Below Normal Continued
start solenoid valve (WP 0216).
Below Normal (WP 0008).
Proceed to Test Step 10.
2417-5 Ether Injection Control
Solenoid Current Below Normal
Remains Active Proceed to Test
Step 2.
Test Step 2. Test Ground Circuit
Function.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove jumper wire from
terminal 1 and terminal 2
of connector L-C6
(WP 0012, Figure 221).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector L-C6
Resistance Greater Than 5.0 Ohms
terminal 2 (WP 0012, Figure 221)
Proceed to Test Step 7.
and ground.
Test Step 3. Test Hood Wiring
Harness for High Resistance or
Open.
1. Connect jumper wire between
terminal 1 and terminal 2
of connector L-C6
(WP 0012, Figure 221).
2. Disconnect connector L-C1
(WP 0012, Figure 190)
from connector J-C2
(WP 0012, Figure 189).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 4.
between connector L-C1
Resistance Greater Than 5.0 Ohms
terminal 8 and terminal 10
Replace hood wiring harness
(WP 0012, Figure 190).
(WP 0389).
Proceed to Test Step 10.
0041-3