TM 5-3805-296-23-1
0041
Table 1. 2417 Start Aid Diagnostic Codes Continued.
041
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 4. Test Chassis Wiring
2417-05 Ether Injection
Harness for High Resistance or
Control Solenoid Current
Open.
Below Normal Continued
1. Remove jumper wire from
terminal 1 and terminal 2
of connector L-C6
(WP 0012, Figure 221).
2. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 5.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 66 (WP 0012, Figure 100)
Replace chassis wiring harness
and J-C2 terminal 8
(WP 0305).
(WP 0012, Figure 189).
Proceed to Test Step 10.
Test Step 5. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Disconnect connector W-C16
(WP 0012, Figure 87)
from connector CL-C3
(WP 0012, Figure 86).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between connector W-C16
Resistance Greater Than 5.0 Ohms
terminal 30 (WP 0012, Figure 87)
Replace main cab wiring harness
and connector W-C1 terminal 66
(WP 0505).
(WP 0012, Figure 99).
Proceed to Test Step 10.
0041-4