TM 9-4940-568-34
3-36
3-10. OUTRIGGER BEAM MAINTENANCE (Continued)
(5) Remove lifting device from outer beam
(5) and attach to inner beam (4).
(6) Raise inner beam (4) with lifting device
so that the end alines with outer beam
(5).
(7) Slide inner beam (4) into outer beam (5).
(8) Apply sealing compound to threads of
eight screws (23) and install two plates
(24) on outer beam (5) with screws (23).
Remove lifting device.
NOTE
Clearance of shims must be 0.06
in. (1.52 mm) at the tightest
point.
(9) Measure clearance between shims (28)
and top of outer beam (5) and between
shims (29) and top of inner beam (4). If
proper clearance is not obtained on
either or both shims, grind shims off and
weld new shims in until proper
clearance is obtained.
(10) Install clamp base (22), hoses (18 and
17) and clamp cover (21) using screw
(20).
(11) Install two adapters (15 and 16) on inner
beam (4).
(12) Install two hoses (18 and 17) and
preformed packings (19) on adapters
(15 and 16).
(13) Install two preformed packings (14) in
adapters (15 and 16).
(14) Install two hoses (12 and 13) and
preformed packings (14) on adapters
(15 and 16).
(15) Install washer (11) and screw (10) in pin
(6).
(16) Install pin (6) in extension cylinder (9)
using washer (8) and screw (7).
14
9
7
8
6
11
10
23
24
4
13
19
18
16
17
19
15
14
12
20
18
21, 22
17
29
28