TM 9-2330-389-14&P
5-2.
INSTALL TRACKED SUSPENSION (Con't).
17.
At rear of trailer, hold rear fender (49) in position over old leveling jack mounting bracket (60). Align holes (61)
with holes (62) in rear fender (49). Using holes (63) in fender (49) as a guide, mark two holes (64) in trailer (65).
18.
Repeat steps 13 through 17 for right side of trailer.
NOTE
If mounting brackets are not needed, omit step 19.
19.
Drill holes marked in steps 13, 14, and 15 with 9/16-inch drill bit on left and right side of trailer.
20.
Drill holes marked in step 17 with 7/16-inch drill bit on left and right side of trailer.
21.
Drill holes marked in step 16 with 3/4-inch drill bit on left and right side of trailer.
22.
Spot-paint exposed metal surfaces in accordance with TM 43-0139, Painting Instructions for Field Use. Do not
paint holes drilled in step 16.
NOTE
If mounting brackets are not needed, omit steps 23 and 24.
23.
Install rear (46), center (47), and forward mounting bracket (48) on left trailer rail (55) with new hex bolts (66), hex
nuts (67), flat washers (68), and lockwashers (69).
24.
Repeat step 23 for right side of trailer.
5-9