TM 9-2330-389-14&P
5-2.
INSTALL TRACKED SUSPENSION (Con't).
2.
Remove three nuts (3), three bolts (4), three
spacers (5), and handbrake assembly (6) from
frame (7).
3.
Remove two self-locking nuts (8), two bolts (9),
and parking brake cable retaining strap (10)
from frame (7). Set aside parking brake cable
retaining strap (10) for later use. Discard self-
locking nuts.
4
Loosen nut (11) on parking brake handle clevis
(12).
5.
Remove cotterpin (13) from straight pin (14).
Remove straight pin (14). Discard cotter pin.
6.
Remove clevis (15) and nut (16) from parking
brake cable (17) and set aside for later use.
7.
Repeat steps 2 through 6 for opposite-side
parking brake cable (7).
8.
Position drain pan to catch hydraulic fluid. Remove hose assembly (18) from multiple connector(19) and tube
assembly (20) by turning both ends at the same time. Set aside hose assembly (18) for later use.
9.
Remove two lubrication fittings (21) from rear upper and lower leaf spring shackle bolts (22). Remove lubrication
fitting (21) from forward leaf spring shackle bolt (22). Discard all three lubrication fittings.
10.
Remove self-locking nut (23) from rear lower leaf spring shackle bolt (22). Discard self-locking nut.
11.
Support spring (24) using a jack stand. Remove shackle bolt (22) and set aside for later use.
12.
Remove four plain nuts (25) from two U-bolts (26). Remove U-bolts (26), plate (27), and four lockwashers (28).
Remove jack stand and lower leaf spring (24) to ground. Discard lockwashers.
13.
Repeat steps 8 through 12 for opposite side.
5-4
