TM 5-3895-376-14&P
4-20. CRANK HANDLE AND GUIDE ASSEMBLY MAINTENANCE INSTRUCTIONS - Continued
2.
Clean guide in dry cleaning solvent and dry thor-
7.
Secure guide assembly with two capscrews (2)
oughly.
and lockwashers (3). Tighten capscrews (2) with
torque wrench fitted with 5 mm hex key driver, to
3.
Install seal (6) into countersunk bore of guide (4),
5.8-7.2 ft.-lbs. (8-10 Nm).
taping gently to seat fully in bore.
4.
Install preformed packing (5) on pilot shoulder of
guide (4) and seat fully in groove at base of pilot.
1
Remove preformed packing (5) and seal (6) from
NOTE
guide (4).
Follow-on tasks include: Return compactor
to service.
WARNING
P-D-680, Type III, is moderately toxic to
the skin, eyes and respiratory tract;
avoid prolonged exposure. Skin and
eye protection is required. Good ventila-
tion is required. Do not use near open
flame or excessive heat. Flash point is
200 F (93.3 C).
4-31