TM 5-3895-376-14&P
4-21. TRANSPORT DOLLY MAINTENANCE INSTRUCTIONS - Continued
j.
Install latch strap (6) on capscrew (9), with
eye protection is required. Good ventila-
notch facing forward while strap is hanging
tion is required. Do not use near open
down.
flame or excessive heat. Flash point is
200 degrees F (93.3 degrees C).
k.
Install box end of wrench (13) over the stem
f.
Clean parts to be reinstalled with cloth damp-
of capscrew (17) and secure with flat
washer (12) and wingnut (11).
ened with cleaning solvent and dry thor-
oughly.
I.
Install locknut (8). Tighten locknut so as to al-
Install new plastic bushings (24) into bore of
low movement of the latch strap (6).
9.
guide bar.
m. Swing the transport dolly up under the guide
h.
Position axle frame (5) under the guide bar
bar and secure with latch strap (6) engaging
as shown and align the bosses with the bush-
the dolly axle.
ings just installed.
i.
Install axle (23) through one boss of axle
frame, the bushings installed in axle
frame (5), and through second boss of axle
3.
Replace the axle frame (5) as follows:
frame.
a.
Remove wheels per instructions of paragraph
Align holes in axle (23) with holes through
j
1 above.
bosses of axle frame (5), and install two cap-
screws (22), locknuts (20) and four flat wash-
Release latch strap (6) and lower the trans-
b.
ers (21) as shown. Tighten locknuts firmly,
port dolly to the ground.
but do not deform the bosses of axle frame.
C.
Remove two locknuts (20), capscrews (22),
Swing axle frame up under the guide bar and
k.
and four flat washers (21).
secure with latch strap (6).
Slide axle (23) from bosses on axle frame (5)
d
I.
Install the two wheels per instructions of para-
and guide bar, freeing the axle frame.
graph 1, above.
Remove plastic flanged bushings (24) from
e.
NOTE
bore through guide bar.
Follow-on tasks include: Return compactor
to service.
WARNING
P-D-680, Type Ill, is moderately toxic to
the skin, eyes and respiratory tract;
avoid prolonged exposure. Skin and
4-34
