TM 5-3895-376-14&P
4-19. DIRECTION CONTROL LEVER MAINTENANCE INSTRUCTIONS - Continued
yoke pins of the control cable IS as de-
wise away from control lever (10). Manually
scribed in the assembly procedures.
shift lever (19) to the down position and then
rotate the eccentric ring (16) counterclock-
a.
Manually set the lever (19) to the down (re-
wise until contact is made with the control
verse) position.
lever (10). Secure eccentric ring in this posi-
tion by tightening capscrew (14) and hex
b.
Shift the control lever (10) fully forward to the
nut (12) securely.
FORWARD travel position and check to see
b.
If vibrator is not shifting into forward, and all
that the lever (19) in now in the raised posi-
tion
parts have been install as described, the con-
trol cable (1) is defective and should be re-
c.
Cycle the control lever to observe the overall
placed.
travel of the control lever. The overall travel
arch of the control lever may be shifted closer
NOTE
to the operator or away from the operator by
If vibrator is not shifting into forward, re-
adjusting the position of the nuts (4) on the
move cover (30). Check to see that
control cable. Set nuts (4) to provide comfort-
screw (32) and washer (33) are securely
able travel of the control lever (10). Tighten
seated. If necessary tighten screw. If there
nuts (4) securely.
is evidence that head of screw (32) or
sleeve (34) is striking the cover (30), add a
d.
Manually shift lever (19) to the down position,
second gasket (31). Reinstall the
Loosen capscrew (14) enough to rotate the
cover (30).
eccentric ring (16) counterclockwise until con-
tact is made with the control lever (10). Se-
3.
Start engine (Para. 2-5) and check vibrator opera-
cure eccentric ring in this position by
tion with control lever (10) shifted in the FOR-
tightening capscrew (14) and hex nut (12) se-
WARD direction and then the REVERSE
curely.
direction.
2.
Adjust for wear in mechanism:
NOTE
Follow-on tasks include: Return compactor
a.
If vibrator is not shifting into reverse, loosen
to service.
the capscrew (14) and rotate eccentric clock-
4-28
