TM 5-3825-230-14&P
a.
Removal.
(1)
Remove six screws (1) using a 5 mm hex head wrench.
NOTE
Tag spring and note its mounting position.
(2)
Remove cover (2) and disconnect spring (3) from lever (4).
(3)
Remove gasket (5) from cover (2).
b.
Disassembly.
(1)
Remove nut (6) and lever (7) using a 13 mm open end wrench.
(2)
Remove nut (8) and lever (9) using a 13 mm open end wrench.
(3)
Remove lever (4), spring (10), and seal (11) using pliers.
(4)
Remove lever (12), spring (13), and seal (14) using pliers .
(5)
Cut lockwire (15).
NOTE
Matchmark positions of screws and nuts to assure correct depth at assembly. (6) Remove two
screws (16) and two locknuts (17) with 10 mm open end wrench.
CAUTION
Tampering with preset screw will cause damage to equipment.
(7)
Do not remove lockwire (18) and screw (19). The screw is preset by the manufacturer.
c.
Assembly.
(1)
Refer to matchmarks and install two locknuts (17), two adjusting screws (16), and lockwire (15) using a 10 mm
open end wrench.
(2)
Install seal (14), spring (13), and lever (12) using pliers.
(3)
Install seal (11), spring (10), and lever (4) using pliers.
(4)
Install lever (9) and nut (8) using a 13 mm open end wrench.
(5)
Install lever (7) and nut (6) using a 13 mm open end wrench.
d.
Installation.
(1)
Install gasket (5) on cover (2) and install spring (3) on lever (4).
(2)
Install cover (2) and six screws (1). Tighten screws to 60 lb-in (7 N•m) using a torque wrench and 5 mm hex
head socket.
NOTE
Follow-on maintenance: Connect throttle control cable and engine cut-off cable (para 4-47)
END OF TASK
5-63
