TM 5-3825-230-14&P
b.
Disassembly.
(1)
Remove retaining ring (1) and washer (2) using
snap ring pliers.
(2)
Separate levers (3 and 4) from control lever (5).
(3)
Remove screw (6), lockwasher (7), and brass
lever (8) using a 6 mm hex head wrench.
(4)
Remove retaining ring (9) using snap ring pliers,
from brass lever (8) and drive out two bearings
(10) using a hammer and drift.
(5)
Remove nut (11), washer (12), and pin (13)
from control lever (5) using a 10 mm open end
wrench.
(6)
Remove retaining ring (14) and drive out bearing (15) from lever (4) using snap ring pliers, hammer and drift.
c.
Cleaning/Inspection.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles, face mask, and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and
don't breathe vapor. Do not use near open flame or excessive heat. The flashpoint for type I dry
cleaning solvent is 100°F (38°C) and for type II is 140°F (60°C). If you become dizzy while using
cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made,
flush eyes with water and get medical aid immediately.
(1)
Clean all parts with dry cleaning solvent P-D-680.
(2)
Inspect bearings for pits, cracks, and signs of wear.
d.
Assembly.
(1)
Install bearing (15) in lever (4) using a hammer and drift and install retaining ring (14).
(2)
Install pin (13) on control lever (5) with washer (11) and nut (12) using a 10 mm open end wrench.
(3)
Install two bearings (10) using a hammer and drift and retaining ring (9), in brass lever (8).
(4)
Install brass lever (8) on control lever (5), screw (6), and washer (7). Tighten using a 6 mm hex head wrench.
(5)
Install control lever (5) on lever (4), and install on lever (3).
(6)
Install washer (2) and retaining ring (1).
5-65
