TM 5-3805-296-23-5
0345
INSTALLATION CONTINUED
NOTE
Remove plugs and caps from air hoses and fittings.
Install air hoses as tagged and marked during removal.
5. Position brake actuator (Figure 6, Item 1) on machine.
6. Install two washers (Figure 6, Item 8) and nuts (Figure 6, Item 9) on brake actuator (Figure 6, Item 1).
7. Install air hose (Figure 6, Item 4) on fitting (Figure 6, Item 2) and tighten tube nut (Figure 6, Item 3).
8. Install air hose (Figure 6, Item 5) on fitting (Figure 6, Item 7) and tighten tube nut (Figure 6, Item 6).
9. Start engine and allow air tanks to charge. Do not apply parking brake (TM 5-3805-296-10).
10. Rotate worm bolt (Figure 6, Item 13) on slack adjuster (Figure 6, Item 14) and align slack adjuster with brake
actuator (Figure 6, Item 1).
11. Install pin (Figure 6, Item 10) and new cotter pin (Figure 6, Item 11) on brake acuator (Figure 6, Item 1) and
slack adjuster (Figure 6, Item 14).
12. Do not tighten lock bolt (Figure 6, Item 12) on slack adjuster (Figure 6, Item 14) at this time.
13. Adjust slack adjusters (Figure 6, Item 14). Refer to Adjustment in this work package.
Figure 6. Brake Actuator.
0345
END OF TASK
