TM 5-3805-296-23-2
0123
Table 1. All Implements Fail To Operate, Cushion Hitch Operates Normally.
0123
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
All Implements Fail To
WARNING
Operate, Cushion Hitch
Operates Normally
DO NOT disconnect or remove any hydraulic system hoses, tubes, or
fittings unless engine is shut down and hydraulic system pressure has
been relieved. Tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool
before removing any hydraulic fitting.
Wear protective eye covering and gloves when performing hydraulic
system testing.
Lubricating/hydraulic oils used in performance of maintenance can be
very slippery. Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to
personnel.
NOTE
Proceed directly to Test Step 2 if sent here by Implement, Cushion Hitch,
and Steering System Operation Test.
Test Step 1. Verify Malfunction is
Active.
Cause of Malfunction Identified and
Perform Implement, Cushion Hitch,
Repaired During Testing
and Steering System Operation Test
(WP 0172).
Troubleshooting complete.
Cause of Malfunction Not Identified
During Testing, Malfunction Active
Proceed to Test Step 2.
Test Step 2. Test Pilot Pressure.
Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
NOTE
Nipple 6V3989 and hose 143516 are from Gauge, Pressure Kit 1U5482.
