TM 5-3805-296-23-2
0080
Table 1. 1292 Transmission Hold Push Switch Diagnostic Codes Continued.
080
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. At MSD, check for active
1292-4 Gear Hold Switch Voltage
1292-04 Gear Hold Switch
diagnostic codes (WP 0008).
Below Normal Becomes Inactive
Voltage Below Normal
Continued
Troubleshooting complete. Proceed to
step 4.
1292-4 Gear Hold Switch Voltage
Below Normal Remains Active
Repeat troubleshooting from the
beginning.
4. Install right trim panels on ROPS
(WP 0494).
NOTE
1292-07 Gear Hold Switch
Mechanical System Not
Always inspect harness connectors that are involved in the circuit. Poor
Responding
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Gear Hold Switch is Stuck in Closed
Position.
POSSIBLE CAUSE
Implement Control Joystick.
Test Step 1. Check for Other Active
Codes.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. Check for active diagnostic code
1292-3 Gear Hold Switch Voltage
1292-3 Gear Hold Switch Voltage
Above Normal Active Diagnose and
Above Normal or code 1292-4
repair active code as described in this
Gear Hold Switch Voltage Below
work package.
Normal in transmission/chassis
1292-4 Gear Hold Switch Voltage
ECM (WP 0008).
Below Normal Active Diagnose and
repair active code as described in this
work package.
Only 1292-7 Gear Hold Switch
Mechanical System Not Responding
Active Proceed to Test Step 2.
0080-17
