TM 5-3805-296-23-2
0080
Table 1. 1292 Transmission Hold Push Switch Diagnostic Codes Continued.
080
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. On MSD, select applicable status
1292-07 Gear Hold Switch
Switch Status Changes Each Time
group (Figure 6, Item 1). View
Mechanical System Not
Jumper Wire is Connected and
Gear Hold Switch status
Responding Continued
Disconnected Replace implement
(Figure 6, Item 2) while performing
control joystick (WP 0503).
the following:
Proceed to Test Step 4.
a. Connect jumper wire between
Switch Status Fails to Change Each
terminal 5 and terminal 6
Time Jumper Wire is Connected and
of connector CG-C14
Disconnected Replace transmission/
(WP 0012, Figure 302).
chassis ECM (WP 0495).
Proceed to Test Step 4.
b. Remove jumper wire from
terminal 5 and terminal 6 of
connector CG-C14
(WP 0012, Figure 302).
c.
Connect jumper wire between
terminal 5 and terminal 7
of connector CG-C14
(WP 0012, Figure 302).
d. Remove jumper wire from
terminal 5 and terminal 7
of connector CG-C14
(WP 0012, Figure 302).
0080-20