TM 5-3805-296-23-2
0081
Table 1. 1293 Cushion Hitch Push Switch Diagnostic Codes.
0081
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
1293-03 Cushion Hitch
Switch Voltage Above
Always inspect harness connectors that are involved in the circuit. Poor
Normal
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Conflicting Input on Cushion Hitch (N/O)
Switch Circuit R756 and Cushion Hitch (N/C) Switch Circuit R757.
POSSIBLE CAUSE
Fuse Panel Wiring Harness High Resistance, Open, or Shorted.
Main Cab Wiring Harness High Resistance, Open, or Shorted.
Implement Control Joystick.
Transmission/Chassis ECM.
Test Step 1. Inspect Implement
Control Joystick Assembly.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Inspect implement control joystick
Joystick Assembly OK Proceed to
assembly for damage (WP 0503).
step 3.
Joystick Assembly Damaged
Replace implement control joystick
(WP 0503).
Proceed to Test Step 12.
3. Press and release cushion hitch
Button Operates Properly Proceed
button several times
to Test Step 2.
(TM 5-3805-296-10).
Button Fails to Operate Properly
Replace implement control joystick
(WP 0503).
Proceed to Test Step 12.
Test Step 2. Test Voltage to Cushion
Hitch Switch.
1. Disconnect connector CG-C14
(WP 0012, Figure 302) from
implement control joystick
connector (WP 0012, Figure 300).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).