TM 5-3805-296-23-2
0080
Table 1. 1292 Transmission Hold Push Switch Diagnostic Codes Continued.
080
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Switch Status Changes Each Time
2. On MSD, select applicable status
1292-04 Gear Hold Switch
Jumper Wire is Connected and
group (Figure 4, Item 1). View
Voltage Below Normal
Disconnected Replace implement
Gear Hold Switch status
Continued
control joystick (WP 0503).
(Figure 4, Item 2) while performing
Proceed to Test Step 8.
the following:
Switch Status Fails to Change Each
a. Connect jumper wire between
Time Jumper Wire is Connected and
terminal 5 and terminal 6
Disconnected Replace transmission/
of connector CG-C14
chassis ECM (WP 0495).
(WP 0012, Figure 302).
Proceed to Test Step 8.
b. Remove jumper wire from
terminal 5 and terminal 6
of connector CG-C14
(WP 0012, Figure 302).
c.
Connect jumper wire between
terminal 5 and terminal 7
of connector CG-C14
(WP 0012, Figure 302).
d. Remove jumper wire from
terminal 5 and terminal 7
of connector CG-C14
(WP 0012, Figure 302).
0080-14
