TM 5-3805-296-23-2
0080
Table 1. 1292 Transmission Hold Push Switch Diagnostic Codes Continued.
080
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Inspect Implement
1292-04 Gear Hold Switch
Control Joystick Assembly.
Voltage Below Normal
1. Turn ignition switch and battery
Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Inspect implement control joystick
Joystick Assembly OK Proceed to
assembly for damage (WP 0503).
step 3.
Joystick Assembly Damaged
Replace implement control joystick
(WP 0503).
Proceed to Test Step 8.
3. Press and release gear hold
Button Operates Properly Proceed
to Test Step 2.
button several times
Button Fails to Operate Properly
(TM 5-3805-296-10).
Replace implement control joystick
(WP 0503).
Proceed to Test Step 8.
Test Step 2. Test Voltage to Gear
Hold Switch.
1. Disconnect connector CG-C14
(WP 0012, Figure 302) from
implement control joystick
connector (WP 0012, Figure 300).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. Using digital multimeter
Voltage 12 0.5 V Proceed to step 4.
(WP 0540), test for voltage
Voltage Less Than 11.5 V Proceed
between connector CG-C14
to Test Step 3.
terminal 6 and terminal 5
(WP 0012, Figure 302).
4. Using digital multimeter
Voltage 12 0.5 V Proceed to Test
(WP 0540), test for voltage
Step 5.
between connector CG-C14
Voltage Less Than 11.5 V Proceed
terminal 7 and terminal 5
to Test Step 6.
(WP 0012, Figure 302).
0080-11
