TM 5-3805-296-23-1
0059
Table 1. 0562 Monitoring System Diagnostic Codes Continued.
059
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
8. Install instrument panel cover
0562-02 Caterpillar
(Figure 6, Item 3) with six washers
Monitoring System Incorrect
(Figure 6, Item 2) and bolts
Signal Continued
(Figure 6, Item 1) on ROPS
(Figure 6, Item 4).
Figure 6. Instrument Panel Cover and Retaining Hardware.
0059
Test Step 11. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove upper and lower plenum
from ROPS (WP 0504).
3. Disconnect connector P-C1
(WP 0012, Figure 253)
from connector W-C7
(WP 0012, Figure 252).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 12.
between connector W-C7
Resistance Greater Than 5.0 Ohms
terminal 39 (WP 0012, Figure 252)
Replace main cab wiring harness
and ground.
(WP 0505).
Proceed to Test Step 13.
Test Step 12. Test Dash Wiring
Harness for High Resistance or
Open.
1. Connect connector P-C1
(WP 0012, Figure 253)
to connector W-C7
(WP 0012, Figure 252).