TM 5-3805-296-23-1
0054
Table 1. 0144 Backup Alarm Diagnostic Code Continued.
054
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test Fuse Panel Wiring
0144-05 Backup Alarm
Harness for High Resistance or
Backup Alarm Relay Current
Open.
Below Normal Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Install flood enable relay on flood
enable relay connector on fuse
panel (Figure 2). Do not install
backup alarm relay at this time.
3. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
4. Connect jumper wire between
terminal E15 and terminal C16 of
backup alarm relay connector
(Figure 3).
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector CG-C1
Resistance Greater Than 5.0 Ohms
terminal 19 and terminal 20
Replace fuse panel wiring harness
(WP 0012, Figure 283).
(WP 0515).
Proceed to Test Step 4.
Figure 3. Backup Alarm Relay Connector Terminals on Fuse Panel.
0054