TM 5-3805-296-23-1
0030
Table 1. 0262 Five-Volt Sensor Supply Diagnostic Codes Continued.
030
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 6. Test for Shorted Fuel
0262-04 Five-Volt Sensor DC
Pressure Sensor.
Supply Voltage Below
1. Turn ignition switch and battery
Normal Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect connector CL-C10
(WP 0012, Figure 32) to connector
CM-C11 (WP 0012, Figure 31).
3. Disconnect connector AW-C1
(WP 0012, Figure 36) from fuel
pressure sensor connector
(WP 0012, Figure 35).
4. Turn battery disconnect switch ON
and start engine
(TM 5-3805-296-10).
262-4 Five-Volt Sensor DC Supply
5. At MSD, check for active
Voltage Below Normal Remains
diagnostic code 262-4 Five-Volt
Active Proceed to Test Step 7.
Sensor DC Supply Voltage Below
262-4 Five-Volt Sensor DC Supply
Normal (WP 0008).
Voltage Below Normal Becomes
Inactive Replace fuel pressure
sensor (WP 0223).
Proceed to Test Step 8.
Test Step 7. Test for Shorted Engine
Interface Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CL-C10
(WP 0012, Figure 32)
from connector CM-C11
(WP 0012, Figure 31).
3. Disconnect connector AW-C4
(WP 0012, Figure 34)
from connector CL-C9
(WP 0012, Figure 33).
4. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C9
Proceed to Test Step 8.
terminal 3 (WP 0012, Figure 33)
No Continuity Proceed to step 5.
and all other terminals
in connector CL-C9
(WP 0012, Figure 33).
0030-11