TM 5-3805-296-23-1
0030
Table 1. 0262 Five-Volt Sensor Supply Diagnostic Codes Continued.
030
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
0262-03 Five-Volt Sensor DC
Continuity Replace basic engine
(WP 0540), test for continuity
Supply Voltage Above
wiring harness (WP 0251). Replace
between connector CM-C1
Normal Continued
engine interface wiring harness
terminal 72 (WP 0012, Figure 30)
(WP 0211).
and all terminals in connector
Proceed to Test Step 4.
CL-C1 (WP 0012, Figure 45).
No Continuity Replace engine ECM
(WP 0252).
Proceed to Test Step 4.
Test Step 3. Test for Shorted Engine
Interface Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector AW-C4
(WP 0012, Figure 34)
from connector CL-C9
(WP 0012, Figure 33).
3. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C9
Proceed to Test Step 4.
terminal 3 (WP 0012, Figure 33)
No Continuity Replace fuel filter
and all other terminals
wiring harness (WP 0233).
in connector CL-C9
Proceed to Test Step 4.
(WP 0012, Figure 33).
0030-5