3
1
2
4
TM 9-4940-568-34
5-106
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
FRS unloaded, (TM 9-4940-568-10)
Generator housing removed, (Para 5-2)
Batteries disconnected, (TM 9-4940-568-10)
Generator set removed (if necessary), (Para 5-3)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 67, Appendix F)
Cap and Plug Set (Item 6, Appendix F)
Engine Turnover Tool (Item 18, Appendix F)
Socket Set, 3/8 in. (Item 52, Appendix F)
Wrench, Torque 3/8 in. Drive (0 to 60 N.m)
(Item 85, Appendix F)
Wrench, Torque (0 to 300 lb-ft [0-470 N.m])
(Item 84, Appendix F)
Lifting Device, Minimum Capacity 500 lbs
(227 kg)
Pin, Alignment (2) (Appendix C)
Pin, Alignment (2) (Appendix C)
Wooden Blocks (4) (Appendix C)
5-21. GENERATOR REPLACEMENT.
Personnel Required
Two
Materials/Parts – Continued
Tags, Identification (Item 36, Appendix B)
Gasket (Item 8, Appendix E)
Locknut (4) (Item 41, Appendix E)
Lockwasher (Item 48, Appendix E)
Lockwasher (8) (Item 50, Appendix E)
Materials/Parts
Cable Ties (Item 5, Appendix B)
Rags, Wiping (Item 23, Appendix B)
a.
Removal.
(1)
Remove four screws (1), locknuts (2) and
electronic overspeed module (3) from
generator back panel (4). Discard locknuts.
