2
3
1
4
5
5
6
10
11
9
LINKAGE
ACTUATOR
YOKE
4
11
TM 9-4940-568-34
5-105
b.
Installation.
Care must be taken when
reinstalling actuator to the fuel
injection pump. Ensure the
actuator yoke is aligned with the
linkage in the fuel injection
pump. With linkage properly
engaged, a slight amount of
pressure will be required to align
the actuator mounting holes.
(1)
Position fuel shutoff valve (4) on fuel
injection pump (11).
(2)
Align fuel shutoff valve (4) with fuel
injection pump (11) and install two screws
(10). Do not tighten screws.
(3)
Install screw (9) in fuel shutoff valve (4)
and fuel injection pump (11). Tighten screw
to 35-45 lb-in (4-5 N.m).
(4)
Tighten two screws (10) to 35-45 lb-in (4-5
N.m).
NOTE
Install wires as noted during
removal.
(5)
Install two wires (6) and screws (5) on fuel
shutoff valve (4).
(6)
Install two sealing washers (2), fuel drain
line (3) and banjo connector screw (1) on
fuel shutoff valve (4).
c.
Follow-On Maintenance:
Install left rear panel, (TM 9-4940-568-10).
Connect batteries, (TM 9-4940-568-10).
END OF TASK
