TM 9-4940-568-34
3-98
3-28. TENSION LOAD CELL REPLACEMENT (Continued)
(13) Remove rear swivel nut (19) from
tension load cell (18).
(14) Remove tension load cell (18) from
boom brace (16).
b.
Installation
(1) Install tension load cell (18) in boom
brace (16) with rear swivel nut (19).
(2) Tighten rear swivel nut (19) until flush
with end.
(3) Route tension load cell cable (12)
through hole in boom brace (16).
WARNING
To prevent personal injury,
extreme care must be taken to
properly
handle
heavy
overhead objects. Make sure
all slings and straps are safe to
use and are secured properly.
Make sure there are no
obstacles in the way. Keep
clear of all suspended loads.
(4) With help from assistant, install lifting
device on hoist assembly (20) and lift up
hoist assembly (20) on tension load cell
(18).
(5) With help from assistant, position front
swivel nut (21) on tension load cell (18).
(6) Adjust front swivel nut (21) on tension
load cell (18) until approximately 0.25 in.
(0.64 cm) of threads are protruding past
rear swivel nut (21).
