TM 9-4940-568-20
5-50
5-12. REMOTE CONTROL BOX REPAIR (Continued)
(24) Remove ground wire (48) from ground
terminal (49).
(25) Remove wire harness (50) from remote
control box (2).
NOTE
Perform Step (26) only if
data plate (52) is damaged,
or if replacing remote
control box.
(26) Drill out and remove four rivets (51),
data plate (52), and ground terminal (49)
from remote control box (2).
b. Assembly
NOTE
Perform Step (1) only if
data
plate
(52)
was
removed.
(1) Install data plate (52) and ground
terminal (49) on remote control box (2)
with four rivets (51).
(2) Apply sealant to four rivets (51) only on
inside of remote control box (2).
(3) Position wiring harness (50) in remote
control box (2).
(4) Install ground wire (48) on ground
terminal (49).
(5) Install four connectors (47) on ON/OFF
switch (46).
NOTE
OFF position of switch
points to rubber key of
washer.
(6) Apply sealant between washer (45) and
ON/OFF switch (46) and install ON/OFF
switch (46) in remote control box (2) with
washer (45), washer (44), nylon washer
(43), switch guard (41) and nut (42).
