TM 9-4940-568-20
5-51
(7) Install
rubber
washer
(40)
and
receptacle (40) in remote control box (2)
with lockwasher (38) and nut (37).
(8) Install cap (36) on receptacle (39).
(9) Install plastic washer (34), chain (33),
and plastic washer (32) on stud (35) with
locknut (31).
NOTE
If circuit card was not
replaced, go to Step (11).
(10) Position heat sink (30) on circuit card
(29).
(11) Install circuit card (29) on controller (18).
NOTE
Spacer (28) is installed
only if circuit card was
replaced.
(12) Install spacer (28) and heat sink (27) on
circuit card (29) with three washers (26)
and screws (24 and 25).
(13) Install spacer (23), insulator (22), and
switch (19) on controller (18) with two
screws (21).
(14) Connect connector (20) on switch (19).
(15) Install insulator (17) and switch (14) on
controller (18) with two screws (16).
(16) Connect connector (15) on switch (14).
(17) Repeat Steps (13 thru 16) for telescope
controller, hoist controller, and boom
controller.
