TM 9-4940-568-20
3-67
e.
Cannon Connector (Plug or Receptacle) Repair or Replacement.
28
31
30
30
31
28
29
31
27
33
27
29
27
REMOVAL
(1)
To remove contacts (27), separate boot (28) from body (29) and slide out of the way.
(2)
Using insertion tool (30), push contact (27) and wire (31) to rear of body (29).
(3)
If body (29) is being replaced, tag and remove all contacts (27). Refer to steps (1) and (2) above.
(4)
If contact (27) is being replaced, cut it from wire (31).
(5)
Remove 1/4 in. (6.3 mm) of insulation (32) from wire (31).
(6)
Insert new contact (27) into crimping tool (33).
(7)
Install bare end of wire (31) into contact (27) and crimp firmly into place.
(8)
Remove wire (31) and contact (27) from crimping tool (33).
(9)
To install contact (27), first install boot (28) onto wire (31) if removed.
(10)
Install insertion tool (30) onto wire (31) and contact (27).
(11)
Using insertion tool (30), install contact (27) and wire (31) into rear of body (29).
(12)
After contact (27) locks in place, remove insertion tool (30).
(13)
If body (29) is being replaced, repeat Steps (9) thru (12) until all contacts (27) have been installed.
(14)
Slide boot (28) all the way onto body (29).
